Why You Should Dry Out Your Incinerator Refractory

After repairing your incinerator refractory, it is important to dry out the moisture in the refractory material by preheating the refractory.

Figure 1: An incinerator in operation

Take note! The moisture released during the thermal decomposition of the hydrates needs to be removed slowly. Preheating the new refractory too quickly may lead to the sudden formation of steam inside, and this generates high steam pressure that may cause the lining to crack or even explode.

Figure 2: The drying out process is sensitive to the rate of temperature increase.

It is important to follow the manufacturer’s recommendations to the letter. When in doubt, always err on the side of the slowest drying rule. Remember: Temperature control is the key to successful drying.

About the author

GIANTECH Engineering is the authorised sales and service agent in Singapore representing various original equipment manufacturers such as Atlas Incinerators and Sunflame Incinerators.

Find out more at: https://www.igiantech.com/services/incinerators/

Do you require more information or assistance? You can contact Justin Si at [email protected] 
Note: This article provides general information only and does not represent formal advice or the positions of any equipment maker.

Categories

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *